Fuel Improvement Devices

FID Open

Heavy fuel oil is not homogenous. Its average droplet size is 70 micron and more. It contains numerous much larger clusters of asphaltenes and other long chain hydro-carbons. Exposing fuel and oil to heat and pressure will unavoidably increase the size and mass of the fuel droplet and negatively impact the combustion process. Using fluid shearing technology, IPCO Power Fuel Improvement Devices reduce fuel droplet size from approximately 70 micron to smaller then 3 micron.

All mineral and organic particles will be divided while catfines and solids, which may lead to abrasive wear and tear, will pass untouched through the ‘Fuel Improvement Device’. These catfines and solids can easily be separated from the fuel with purifiers and fine-filters. “The smaller each injected droplet of fuel, the more homogeneous the distribution in the cylinder and the more intensive the contact with oxygen. This provides an even better carburetion and consequently enlarges the quality of the combustion.”

FID Reducer; significantly reduce size and mass of fuel droplets. With much smaller HFO droplets, centrifuges and filters will more effectively remove in-organic contaminants and stay clean much longer. Centrifuge flushing intervals will be extended and sludge generation reduced by approx 80%.

FID Impover; is there to create a better combustion. The smaller each injected droplet of fuel, the more homogeneous the distribution in the cylinder and the more intensive the contact with oxygen. The FID Improver will enhance combustion, reducing fuel consumption and emissions.

Effective Combustion

FID Injector; treats the fuel with free water into a stable water in fuel emulsion. The injection of emulsified fuel into the engine enables effective atomization and good distribution of the fuel in the combustion chamber. This results in more complete combustion with lower fuel consumption, a cleaner engine and a reduction in the amount of NOx, HC and PM pollutants. The reduction of NOx emission is based on the reducing of high peak temperatures.

Injector Certificates

The FID product line has the following certificates

Products